Installation of SLES 10 SP3 fails when run from a hard disk on a system with an unpartitioned USB device
This document (7005328) is provided subject to the disclaimer at the end of this document.
Steps to Reproduce1. Setup a system with a hard disk with the SLES 10 SP3 installation source on it.
2. Plug a USB device without any partition into the system.
4. Continue the install normally until the system reboots.
6. The disk with the installation source cannot be mounted through a console ( Ctrl+Alt+F2) either. The message states that the disk is already mounted/busy.
This Support Knowledgebase provides a valuable tool for NetIQ/Novell/SUSE customers and parties interested in our products and solutions to acquire information, ideas and learn from one another. Materials are provided for informational, personal or non-commercial use within your organization and are presented "AS IS" WITHOUT WARRANTY OF ANY KIND.
- Document ID:7005328
- Creation Date:09-FEB-10
- Modified Date:27-APR-12
- SUSESUSE Linux Enterprise Server
Did this document solve your problem? Provide Feedback< Back to Support Search