samba-winbind 100% CPU utilisation
This document (7019036) is provided subject to the disclaimer at the end of this document.
SUSE Linux Enterprise Server 12 Service Pack 1 (SLES 12 SP1)
SUSE Linux Enterprise Server 11 Service Pack 4 (SLES 11 SP4)
SUSE Linux Enterprise Server 11 Service Pack 3 (SLES 11 SP3)
SUSE Linux Enterprise Server 11 Service Pack 2 (SLES 11 SP2)
SUSE Linux Enterprise Server 11 Service Pack 1 (SLES 11 SP1)
SUSE Linux Enterprise Desktop 12
SUSE Linux Enterprise Desktop 11 Service Pack 4 (SLED 11 SP4)
SUSE Linux Enterprise Desktop 11 Service Pack 3 (SLED 11 SP3)
SUSE Linux Enterprise Desktop 11 Service Pack 2 (SLED 11 SP2)
SUSE Linux Enterprise Desktop 11 Service Pack 1 (SLED 11 SP1)
The AD setup is with multiple domains, however the SLES system is located in a network section that blocks access to all "sub" DCs, so winbind can not reach some DCs in the network, but gets the information about this DCs from AD. This results in winbind constantly trying to connect to the not reachable DCs, but it fails. In the logs (with debug enabled) you can find messages like this:
find_new_dc: smbsock_any_connect failed for domain XXX address a.b.c.d. Error was NT_STATUS_IO_TIMEOUT
an strace or tcpdump will show excessive connect attempts to the not reachable DCs
winbind:ignore domains = DOMAIN1,DOMAIN2,DOMAIN3
afterward restart winbind.
This Support Knowledgebase provides a valuable tool for NetIQ/Novell/SUSE customers and parties interested in our products and solutions to acquire information, ideas and learn from one another. Materials are provided for informational, personal or non-commercial use within your organization and are presented "AS IS" WITHOUT WARRANTY OF ANY KIND.
- Document ID:7019036
- Creation Date:23-MAY-17
- Modified Date:23-MAY-17
- SUSESUSE Linux Enterprise DesktopSUSE Linux Enterprise Server
Did this document solve your problem? Provide Feedback< Back to Support Search