|
 | IBM zEnterprise 114 z114 (2818)
Network Server
IBM | 19 Jul 2011
135903 |
SUSE YES Certified for the following products:
Operating Systems:
| SUSE® Linux Enterprise Server 11 for IBM Power™ Service Pack 3 for SUSE® SLES 11 |
Product Description
SLES-11 SP1-s390x on an IBM® zEnterprise™ System.
Tested Configuration:
| Computer Type: | System z Platform |
| Mother Board Revision: | n/a |
| BIOS/uEFI: | n/a |
| CPU: | IBM
System z processor running 64 bit mode |
| RAM: | 6 GB |
| Ports and Bus Types: | System z |
| Host Bus Adapter: | IBM
SCSI/FCP
, SCSI IBM
Ficon Express4
, FibreChannel IBM
Escon
, FibreChannel IBM
Ficon Express8
, FibreChannel |
| Hard Disk Drive: | IBM
FICON DASD Storage Device
, FibreChannel IBM
SCSI/FCP Disk Storage Device
, SCSI IBM
ECKD DASD Storage Device
, FibreChannel |
| Test Kit: | System Certification Kit 6.6.0-34.1 |
Config Notes
- Install: The SUSE® Linux Enterprise Server install was performed using a network install method.
- Headless configuration - no graphics adapter. System configured using IBM remote Hardware Management Console (HMC) for graphics, keyboard and mouse.
- Power management: The System/Processor dynamic CPU frequency scaling functionality in SLES is not supported on POWER8 as this functionality is provided by the POWER8 hardware itself.
- Required configuration: SLES 11 SP3 will run in POWER7 Compatibility mode. 'Compatibility mode' simply means that the POWER8 processor with SMT8 will act as though it were a POWER7 processor with SMT4.
- SUSE update ISO: The SLES-11-SP3-MINI-ISO-power8.iso is SUSE SolidDriver Program compliant. This update must be downloaded and used before SUSE Linux Enterprise Server install. To obtain the driver go to: http://drivers.suse.com/ibm/IBM-POWER/sle11-sp3/install-readme.html and review the installation instructions.
- Kdump: the crash kernel reserved memory parameters were changed based on the content in the following knowledge-base article: http://www.novell.com/support/kb/doc.php?id=3374462.
|
Adapters and Drivers
| | | | | |
| IBM
SCSI/FCP |
| IBM
Ficon Express4 |
| IBM
Escon |
| IBM
Ficon Express8 |
| IBM
OSA-Express2 |
| IBM
OSA-Express3 |
The term SUSE YES Certified applies only to the exact configuration documented in this bulletin.
For more information on hardware exchange policies, please access the following document and view the Hardware Component Exchange Guide.
https://www.suse.com/product-certification/yes-certified/certification-requirements/
For more information regarding the specific test configuration, please contact:
IBM
For support regarding this specific configuration, please visit:
www.ibm.com
|